There's a lot of discussion about risk of damaging the hood by slamming the hood down when closing the frunk.
TM recommends two open palms evenly spaced around the center of the font edge, with a gentle but firm press.
Alternatives are discussed here, but apparently they too are vulnerable, so play it safe - avoid closing the frunk a lot, and if you need to use it, read up on what TM says about doing it right. This thread provides user experiences for additional insights into how and why it can get damaged.
I studied the frunk latch mechanism and experimented, and found what I thought was a better way (but some report problems with this too).
I use firm palm pressure at a single point directly above the latch. It can be one or two palms, but the point is for all the force to be right above the latch hardware (Caution! Latch is set back about 4-6 inches from the front edge of the hood, so don't press at the front edge or you will crease it. Owners have reported creases when doing this.
By not straddling the latch with a wide stance, the idea is to reduce the risk of uneven side forces that might tweak the aluminum hood stamping. Applying cantilevered forces perfectly in balance is hard for a human to do consistently. The single point press may be easier to do right, to prevent any tweaking torsional force (but if you are too close to the front edge, you can cause the same crease problem from front to back - so be careful).
Anybody else looked at this?
Some owners have reported creasing their hood even when carefully applying pressure at a single location directly over the latch. Others have reported creases when using two separate palm pressure points with both hands as Tesla recommends. A consensus among many owners is forming that the current frunk closing procedure is too subtle and too delicate to be consumer-grade.
Hoping that TM updates this latch setup to make it a simple auto-closing operation.